| [Flash Point] 58 | |
| [Fire Fighting] Use water in flooding quantities as fog. Use foam, dry chemical, or carbon dioxide. Cool all affected containers with flooding quantities of water. Apply water from as far a distance as possible. Keep run-off water out of sewers and water sources. | |
| [Fire Potential] This chemical is flammable. | |
| [Ingestion] DO NOT INDUCE VOMITING. Corrosive chemicals will destroy the membranes of the mouth, throat, and esophagus and, in addition, have a high risk of being aspirated into the victim's lungs during vomiting which increases the medical problems. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. IMMEDIATELY transport the victim to a hospital. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. Transport the victim IMMEDIATELY to a hospital. | |
| [Inhalation] IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used. | |
| [Skin] IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. IMMEDIATELY call a hospital or poison control center even if no symptoms (such as redness or irritation) develop. IMMEDIATELY transport the victim to a hospital for treatment after washing the affected areas. | |
| [Eyes] First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop. | |
| [Storage] Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage. | |
| [Handling] All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood. | |
| [Inhalation] Highly toxic, may be fatal if inhaled, swallowed or absorbed through skin. Effects of contact or inhalation may be delayed. | |
| [Skin] Contact with molten substance may cause severe burns to skin and eyes. Avoid any skin contact. | |
| [Eyes] See Skin. | |
| [Hazards] Containers may explode when heated. Runoff may pollute waterways. Substance may be transported in a molten form. | |
| [EC Risk Phrase] R 21/22 26 34 | |
| [EC Safety Phrase] S 26 28 36/37/39 45 | |
| [UN (DOT)] 3302 | |
| [Personal Protection] If Tyvek-type disposable protective clothing is not worn during handling of this chemical, wear disposable Tyvek-type sleeves taped to your gloves. | |
| [Respirators] When working with this chemical, wear a NIOSH-approved full face chemical cartridge respirator equipped with the appropriate organic vapor cartridges. If that is not available, a half face respirator similarly equipped plus airtight goggles can be substituted. However, please note that half face respirators provide a substantially lower level of protection than do full face respirators. | |
| [Exposure Effects] The toxological properties of this substance have not been fully investigated. | |
| [Appearance] A colorless to light yellow liquid with an acrid odor. | |
| [Solubility in water] Very soluble | |
| [Melting Point] <-60 | |
| [Boiling Point] 177 | |
| [Vapor Pressure] 1 (25 C) | |
| [Density] 0.9406 g/cm3 (20 C) | |
| [pKa/pKb] 5.79 (pKb) | |
| [Partition Coefficient] .95 | |
| [Heat Of Vaporization] 41.4 kJ/mol | |
| [Refractive Index] 1.4372 (20 C) | |
| [Product Name] N,N-Dimethylaminoethyl acrylate | |
| [Synonyms] 2-(Dimethylamino)ethyl acrylate | |
| [CAS] "CASEN_2439-35-2.htm">2439-35-2 | |
| [Formula] C7H13NO2 | |
| [Molecular Weight] 143.21 | |
| [EINECS] 219-460-0 | |
| [RTECS] AS8578000 | |
| [RTECS Class] Mutagen | |
| [Beilstein/Gmelin] 1099119 | |
| [Beilstein Reference] 4-04-00-01431 | |
| [Small spills/leaks] Keep material out of water sources and sewers. Use water spray to knock-down vapors. Land spill: Dig a pit, pond, lagoon, holding area to contain liquid or solid material. Dike surface flow using soil, sand bags, foamed polyurethane, or foamed concrete. Absorb bulk liquid with fly ash, cement powder, or commercial sorbents. Water spill: Use natural barriers or oil spill control booms to limit spill travel. Remove trapped material with suction hoses. | |
| [Incompatibilities] Incompatible with isocyanates, halogenated organics, peroxides, phenols (acidic), epoxides, anhydrides, and acid halides Flammable gaseous hydrogen is generated in combination with strong reducing agents, such as hydrides Strong oxidizing acids may cause a vigorous reaction that is sufficiently exothermic to ignite the reaction products. | |
| [Stability] No data. | |
| [Combustion Products] Fire may produce irritating, corrosive and/or toxic gases. | |
| [UN Number] 3302 | |
| [Hazard Class] 6.1 | |
| [Packing Group] II |
Print