[Fire Fighting] Extinguish fire with flooding quantities of water or use dry chemical or carbon dioxide. | |
[Fire Fighting] Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. | |
[Fire Potential] This material is probably combustible. | |
[Fire Potential] EXTREMELY FLAMMABLE. Will be easily ignited by heat, sparks or flames. Will form explosive mixtures with air. | |
[Ingestion] DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. | |
[Ingestion] Seek medical assistance. | |
[Inhalation] Vapors may cause dizziness or asphyxiation without warning. Some may be irritating if inhaled at high concentrations. | |
[Inhalation] IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used. | |
[Inhalation] Move victim to fresh air. Apply artificial respiration if victim is not breathing. Administer oxygen if breathing is difficult. | |
[Skin] IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment. | |
[Skin] Remove and isolate contaminated clothing and shoes. Clothing frozen to the skin should be thawed before being removed. In case of contact with liquefied gas, thaw frosted parts with lukewarm water | |
[Skin] Contact with gas or liquefied gas may cause burns, severe injury and/or frostbite. | |
[Eyes] May cause irritation. | |
[Eyes] First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop. | |
[Eyes] Flush with running water for at least 20 minutes. | |
[Storage] Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage. | |
[Handling] All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood. | |
[Ingestion] See inhalation. | |
[Inhalation] This chemical is a strong allergen and the reaction may be severe in susceptible people. Symptoms of exposure to this compound include hypersensitivity, skin rashes (ranging from maculopapular eruptions to exfoliative dermatitis), urticaria, chills, fever, edema, arthralgia, prostration, severe and occasionally fatal anaphylaxis, hemolytic anemia, leukopenia, thrombocytopenia, neuropathy and nephropathy. Subsequent exposures can lead to more serious reactions of the serum sickness type. | |
[Skin] See inhalation. | |
[Eyes] See inhalation | |
[Hazards] Vapors from liquefied gas are initially heavier than air and spread along ground. Vapors may travel to source of ignition and flash back. Containers may explode when heated. | |
[EC Risk Phrase] R 11 | |
[EC Safety Phrase] S 9 16 23 33 | |
[UN (DOT)] 3161 | |
[Personal Protection] Chemical splash goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other type safety glasses. Whre chemical resistant gloves. To prevent repeated or prolonged skin contact, wear impervious clothing and boots. | |
[Personal Protection] Wear appropriate protective gloves, clothing and goggles. Always wear thermal protective clothing when handling refrigerated/cryogenic liquids. | |
[Respirators] Wear positive pressure self-contained breathing apparatus (SCBA). | |
[Respirators] Wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. | |
[Appearance] White to slightly yellow crystalline powder with a faint odor. | |
[Melting Point] 255 | |
[Boiling Point] 18 | |
[Density] 1.38 g/cm3 | |
[Usage] Antibiotic. | |
[Product Name] 3,3-Dimethyl-7-oxo-6-(2-phenyl-acetamido)-4-thia-1-azabicyclo[3.2.0]heptane-2-carboxylic acid monosodium salt | |
[Synonyms] (Trifluoromethyl)acetylene 3,3,3-Trifluoroprop-1-yne 3,3,3-Trifluoropropyne 4-Thia-1-azabicyclo(3.2.0)heptane-2-carboxylic acid, 3,3-dimethyl-7-oxo-6-(2-phenyl acetamido)-, monosodium salt Crystapen Novocillin Sodium (2S,5R,6R)-3,3-dimethyl-7-oxo-6-[(2-phenylacetyl)amino]-4-thia-1-azabicyclo[3.2.0]heptane-2-carboxylate Veticillin | |
[CAS] "CASEN_661-54-1.htm">661-54-1 | |
[CAS] "CASEN_69-57-8.htm">69-57-8 | |
[Formula] C16H17N2NaO4S | |
[Formula] C3HF3 | |
[Molecular Weight] 356.37 | |
[EINECS] 200-710-2 | |
[EINECS] 211-548-7 | |
[RTECS] XH9800000 | |
[RTECS Class] Tumorigen; Drug; Mutagen; Reproductive Effector; Natural Product | |
[Beilstein/Gmelin] 1740172 | |
[Beilstein/Gmelin] 3834217 | |
[Beilstein Reference] 4-01-00-00962 | |
[Beilstein Reference] 4-27-00-05861 | |
[Small spills/leaks] If you spill this chemical, you should dampen the solid spill material with water, then transfer the dampened material to a suitable container. Use absorbent paper dampened with water to pick up any remaining material. Seal your contaminated clothing and the absorbent paper in a vapor-tight plastic bag for eventual disposal. Wash all contaminated surfaces with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned. | |
[Small spills/leaks] Make no contact with the spilled material. ELIMINATE all ignition sources, combustibles and ground all equipment. Take up with sand or other noncombustible absorbent material and place into containers for later disposal. | |
[Incompatibilities] Incompatible with acids, oxidizing agents (especially in the presence of trace metals), heavy metal ions such as copper, lead, zinc and mercury; glycerol, sympathomimetic amines, thiomersal, wood alcohols, cetostearyl alcohol, hard paraffins, macrogols, cocoa butter and many ionic an nonionic surface-active agents Incompatible with alkalis, compounds leached from vulcanized rubber, hydrochlorides of tetracyclines and organic peroxides Incompatible with naphthalene oils and vitamin B. | |
[Stability] No data. | |
[UN Number] 3161 |